Homelink® Garage Opener - Acura MDX 2015 Owner's Manual

veHICLe CoNTroLS
Folding Down the Second-row Seats
Separately fold down the left and right halves of the second-row seat to make room for
cargo.
1. Store the center seat belt by inserting the latch plate
into the slot on the side of the anchor buckle.
2. Retract the seat belt into the holder on the ceiling.
3. Lower the center head restraint to its lowest position.
Put the armrest back into the seat-back.
4. Pull up the seat-back angle adjustment lever.
To return the seat to its original position, pull up the seat-back to an upright position
until it is securely latched into place. Reposition the seat belts as necessary.
Folding Down the Third-row Seats
Separately fold down the left and right halves of the third-row seat to make room for
cargo.
1. Pull the handle on the seat-back. The head restraint
folds down.
2. Push the seat-back forward while pulling the handle.
To return the seat to its original position, pull up the seat-
back while pulling up the handle. Push the head restraint
up to its original position.
44 |
HomeLink® Garage opener
Program your vehicle to operate up to three remote-controlled devices around your home—
such as garage doors, lighting, or home security systems—using the buttons on the ceiling.
Lever
Training a Button
Park near the system you want to program, and follow the instructions in the flowchart
below.
1
2
Press and hold the desired HomeLink
button and the button on the remote
transmitter.
Does the HomeLink indicator (LED) blink at a faster
rate after about 10 seconds?
NO
Handle
a
Press and hold the button on the remote
and the HomeLink button at the same
time. Then, while continuing to hold the
HomeLink button, press and release the
button on the remote every 2 seconds.
Does the LED blink at a faster rate within 20 seconds?
NO
To retrain a button or erase codes, see the Owner's Manual on the Owner Information
CD or at owners.acura.com (U.S.) or myacura.com (Canada). If you need help, visit
homelink.com.
3 Press and hold the programmed
Position the remote transmitter
HomeLink button for about a second.
1–3 inches (3–8 cm) from the
HomeLink button you want to program. Does the device (garage door opener) work?
4
Press and hold the
HomeLink button
again.
HomeLink indicator
YES
flashes for 2 seconds,
then remains on.
a
The remote has a rolling code. Press
the "learn" button on the
remote-controlled device (e.g., garage
door opener).
b
Within 30 seconds, press and hold the
YES
programmed HomeLink button for 2
seconds.
5
Press the programmed HomeLink
button again; the remote-controlled
device should operate.
veHICLe CoNTroLS
HomeLink buttons
HomeLink indicator
NO YES
Training
complete
HomeLink LED
remains on.
www.
| 45