Acura MDX 2015 Owner's Manual page 13

SAFeTy
Installing a LATCH-Compatible Child Seat
A LATCH-compatible child seat can be installed in the second-row seats. A child seat is
attached to the lower anchors with either the rigid or flexible type of connectors.
1. Locate the lower anchors under the marks.
2. Place the child seat on the vehicle seat, then attach
the child seat to the lower anchors according to the
instructions that came with the child seat. Make sure
that the lower anchors are not obstructed by the seat
belt or any other object.
outer seats: Raise the head restraint to its
highest position, then route the tether strap
between the head restraint legs, and secure the
tether strap hook onto the anchor.
Center seat: Lower the center head restraint to
its lowest position, then route the tether strap
over the top of the head restraint and secure the
tether strap hook onto the anchor.
3. Tighten the tether strap as instructed by the child seat
maker.
4. Make sure the child seat is firmly secured by rocking
it forward and back and side to side; little movement
should be felt.
5. Make sure any unused seat belt that a child can reach is
buckled, the lockable retractor is activated, and the belt
is fully retracted and locked.
18 |
Marks
Lower anchors
Rigid type
Flexible type
Tether strap hook
Anchor
Installing a Child Seat with a Lap/Shoulder Seat Belt
1. Place the child seat on the vehicle seat.
2. Route the seat belt through the child seat according to
the seat maker's instructions, and insert the latch plate
into the buckle. Insert the latch plate fully until it clicks.
3. Slowly pull the shoulder part of the belt all the way out
until it stops. This activates the lockable retractor.
4. Let the seat belt completely wind up into the retractor,
then try to pull it out to make sure the retractor is
locked. If you are able to pull the shoulder belt out, the
lockable retractor is not activated. Pull the seat belt all
the way out, and repeat steps 3 – 4.
5. Grab the shoulder part of the seat belt near the buckle,
and pull up to remove any slack from the lap part of the
belt. When doing this, place your weight on the child
seat and push it into the vehicle seat.
6. Make sure the child seat is firmly secured by rocking
it forward and back and side to side; little movement
should be felt.
7. Make sure any unused seat belt that a child can reach is
buckled, the lockable retractor is activated, and the belt
is fully retracted and locked.
To deactivate a lockable retractor, release the buckle and
allow the seat belt to wind up all the way.
SAFeTy
| 19