Service Parts Changes (Before Serial # 22020); Switch Box Assembly - Wellsaw 58BD Operating & Maintenance Manual

Before 17240 to 21035
Beginning 20855
Beginning 21036
To Serial Number 11751
From Serial Number 11752
To Serial Number 11885
To Serial Number 22020
1. Disconnect power.
2. Remove existing cover.
3. Remove wire nut (A) and add white pigtail with push connector.
4. Cut off red motor wire (B) from both ends of motor cord.
5. Connect black wire (C) from motor and wet saw pigtail (C) to toggle switch terminal (E).
6. Cut off existing terminal on black power wire (D) and replace with push terminal supplied.
7. Connect new white pigtail to relay coil terminal (F).
8. Connect black power wire (D) with new push terminal to relay line terminal (G)
9. Install cover on switch box.
10. Saw operation. Push reset button only after loss of power. Normal saw operation is by toggle switch.
58B Service Parts Changes
ELECTRICALS
100670-1 (Switch Only) or 102888 Switch Box Assembly
105869 Safe Start Plus and Cord Set
120228 Switch Assembly & 100846-16 Motor
BLADE GUIDES
102858 Frame Ratchet
102908 Guide Bracket Idle End
102912 Guide Bracket Drive End
101322 Roller Guide Assembly
105828 Frame Ratchet
105832 Idle Guide Bracket End
105830 Guide Bracket Drive End
101322 Roller Guide Assembly
BLADE GUARDS
102963 Blade Guard Idle End
102949 Blade Guard Drive End
102961 Pivot Rod
Current Idle Wheel Guard Assembly could replace old assembly
using the following parts:
105868 Idle Wheel Guard Assembly
105860 Roller Axle
WHEEL KITS
102931 Wheel and Handle Kit for fi eld installation

120229-00? Switch Box Assembly

16