Mount The Arm Band And Attach The Terminal - Honeywell Dolphin 70e User Manual

Mount the Arm Band and Attach the Terminal

It is recommended that each user have their own arm band for hygiene reasons. The arm band can be washed between
uses. Be sure to remove the sled from the arm band before washing the arm band.
Note: The illustrations in this procedure assume the sled has not yet been mounted to the arm band. However the sled can
be mounted to the arm band before the user puts the arm band on.
1. If the arm band straps are not fed through the buckles, feed them through to form a loop before placing the arm band
on the arm. For ease of installation, the straps should be kept looped through the buckles.
2. Place and balance the arm band assembly on the top of the desired arm with the buckles toward the outside of the arm.
3. Using the other hand, pull each strap end straight away from the arm until the
arm band is comfortably secured.
4. Ensure the latch on each buckle is through a hole in the strap.
1. If there is excess strap length:
• Loop the excess strap behind the
horns on the sled, as shown, or
2 - 3