Table of Contents
Advertisement
Link Quality ("Q") will be the most important elements, and others are for reference only.
Q (Link Quality)
0 ~ 10 Very Poor
10 ~15 Poor
15 ~30 Good
50 ~80 Very Good
3.3 Application
The Application module runs on top of the System module. The SP5600 Terminal is preloaded with
the Application Generator's run-time program and the following menu will be shown upon powering
the unit up:
1. Take data
2. Utilities
The arrow keys can be used to select the menu item, and execute it by pressing the ENTER key. Note
if you use the Application Generator to create your application program, you need to download it to
the terminal. And for RF models, you need to use the RF Database Manager to handle the in-coming
and out-going data to and from the PC. For detailed information, please refer to "8300 Series
Application Generator User's Guide" and "RF Application Generator User's Guide".
3.4 Programming the terminal
There are three software tools available for developing application programs for the terminal.
1. The Application Generator
2. The "BASIC" Compiler
3. The "C" Compiler
Besides, Terminal Emulation program which supports ANSI (VT100& VT220) and IBM is also
available. For detailed information, please contact Syntech Information Co., Ltd.
3.5 Programming the communication cradle
The communication cradle of the SP5600 Portable Data Terminal supports serial IR interface only.
Before your PC application starts to communicate with the terminal via its cradle, first you need to
configure the cradle through programming. There is a DLL available for this purpose. For more
information, please contact your supplier .Syntech Information Co., Ltd.
T ( Transmit Speed)
S (Signal Level)
1M bps
0 ~ 10 Weak
2M bps
30~60 Moderate
5.5M bps
Over 60 Strong
11M bps
11
N ( Noise Level)
1
Weak
2~3 Moderate
4~5 Strong
Advertisement
Table of Contents
