Connecting To The Internet Via 3G; Inserting The Sim Card - TrekStor SurfTab xiron 7.0 3G Operating Instructions Manual

Table of Contents

Advertisement

14) Connecting to the Internet via 3G

The 3G function on your SurfTab means that you are independent of available
WiFi networks. You connect to the network via your mobile communications
provider.

Inserting the SIM card

Only insert the SIM card when the device is completely switched off. The card
will not be recognised if the device is in standby mode.
It is advisable to use mini SIM cards and forego micro SIM cards with adapters.
i
a)
Remove the cover on the rear side of your SurfTab by reaching into the slit
intended for this purpose and carefully pulling the cover upwards.
Use your fingernail or a similarly thin lever to reach into the opening.
i
Do not use any pointed or sharp-edged instruments.
b) Insert the SIM card from your data service provider into one of the available
SIM slots. The golden contacts on the SIM card should face the rear side of
the device and the slanted corner should be in the top left.
The illustration on the dual SIM slot provides further assistance in inserting the
i
SIM card.
Do not insert any microSD/SDHC- memory cards into the dual SIM slot! If a
a
memory card does become stuck in the dual SIM slot, have it removed by a
trained professional.
c)
Replace the cover.
The device cover contains the antenna for WiFi, GPS and Bluetooth.
i
Pay particular attention here to the correct seating of the device cover after
re-attaching to avoid disturbances and problems in reception.
When you switch on your SurfTab again after inserting the SIM card, you have
i
to enter the corresponding PIN number, if available.
EN
19

Advertisement

Table of Contents
loading

Table of Contents