Canon mp628 Service Manual page 8

The connected digital [2001]
camera or digital video
camera does not support
Camera Direct Printing.
The remaining ink [1683] U130 (Applicable ink tank icon)
amount unknown (raw
ink present).
Ink tank not recognized. [1684] U140 The following ink tank cannot be
Ink tank not recognized. [1410
1419]
No ink (no raw ink). [1688] U163 Printer detected ink out condition of
Non-supported hub [2002]
Time-out for the scanner [2700]
device
--- The device may be incompatible.
Remove the device and check the
manual supplied with the connected
device.
The remaining level of the following
ink cannot be correctly detected.
Replace the ink tank.
recognized.
(Applicable ink tank icon)
U150 The following ink tank cannot be
to recognized.
(Applicable ink tank icon)
the following ink. Replace the ink
tank.
(Applicable ink tank icon)
--- An unsupported USB hub is
connected. Remove the hub.
--- Timeout error has occurred. Press
[OK].
However, when the ink absorber becomes full, no
further printing can be performed unless the
applicable ink absorber is replaced.
Remove the cable between the camera and the
machine.
An ink tank which has once been empty is installed.
Replace the applicable ink tank with a new one.
Printing with a once-empty ink tank can damage the
machine.
To continue printing without replacing the ink tank
(s), press the Stop button for 5 sec. or longer to
disable the function to detect the remaining ink
amount. After the operation, it is recorded in the
machine EEPROM that the function to detect the
remaining ink amount was disabled.
A non-supported ink tank (an ink tank that is sold in
a different region from where the machine was
purchased) is installed (the ink tank LED is turned
off). Install the supported ink tanks.
A hardware error occurred in an ink tank (the ink
tank LED is turned off). Replace the ink tank(s).
Replace the empty ink tank(s), and close the
scanning unit (cover).
Printing with an empty ink tank can damage the
machine.
To continue printing without replacing the ink tank
(s), press the Stop button for 5 sec. or longer to
disable the function to detect the remaining ink
amount. After the operation, it is recorded in the
machine that the function to detect the remaining
ink amount was disabled.
Remove the applicable USB hub from the
PictBridge (USB) connector.
The buffer became full in the middle of scanning
operation, and 60 minutes have elapsed since then,
making re-scanning unstable. Press the OK button
to clear the error.
6 / 44