Canon mp628 Service Manual page 10

8 times Print head
temperature rise
error
9 times EEPROM error
10 times VH monitor error
11 times Carriage lift
mechanism error
12 times APP position error
14 times APP sensor error
Paper feed cam
sensor error
15 times USB Host VBUS
overcurrent
16 times Pump roller sensor
error
19 times Ink tank position
sensor error
20 times Other errors
21 times Drive switch error
5B00: Main ink absorber is full
(overseas).
5B01: Main ink absorber is full
(Japan).
[5200] The print head temperature
exceeded the specified value.
[6800, A problem occurred in reading from
6801] or writing to the EEPROM.
[B200] The internal temperature exceeded
the specified value.
[5110] The carriage did not move up or
down properly.
[6A80] An error occurred in the APP motor. (1) Foreign material or paper debris around the
[6A90] An error occurred during paper
feeding or purging.
[6B10] An error occurred in the paper feed
cam sensor during paper feeding
from the cassette, or the paper
absorbing a large amount of ink
jammed in the PF rear guide.
[9000] The USB Host VBUS is overloaded. (1) Part replacement:
[5C20] The pump roller position cannot be
detected.
[6502] None of the ink tank position is
detected.
[6500] An unidentified error or a network
error occurred.
[C000] Drive was not switched properly.
8 / 44
(1) Print head condition
(2) Cable connection
(3) Part replacement:
- Print head
- Logic board
(1) Part replacement:
- Logic board
(1) Part replacement:
- Print head and logic board (Replace
them at the same time.)
- Power supply unit
(1) Foreign material or paper debris that
obstructs the carriage movement;
remove foreign material.
(2) Part replacement:
- Switch system unit
- Carriage unit
purge drive system unit;
remove foreign material.
(2) Foreign material or paper debris around the
ASF unit;
remove foreign material.
(3) Cable connection
(4) Part replacement:
- Purge drive system unit
- Logic board
(1) Jammed paper in the PF rear guide (when a
large amount of ink was absorbed in the
paper);
remove the jammed paper and foreign
material.
(2) Foreign material or paper debris in the
cassette or in the PF rear guide;
remove foreign material.
(3) Part replacement:
- PF pick-up unit
- Logic board
- Logic board
(1) Cable connection
(2) Part replacement:
- Purge drive system unit
(1) Ink tank position;
confirm the ink tank position.
(2) Re-set or replacement of ink tanks
(3) Cable connection
(4) Part replacement:
- Spur unit
- Logic board
(1) Part replacement:
- Logic board
- WLAN board
(1) Foreign material or paper debris in the drive