Table of Contents
Advertisement
battery charging
New batteries are not fully charged.
See "Battery Use and Safety" on page 83.
charge using the charger
1 Pull out the connector cover, and insert
the charger into the accessory connector
on your phone as shown.
2 Plug the other end of the charger into the
appropriate electrical outlet.
When you charge the battery, the battery level
indicator at the upper right of the screen
shows charging progress. At least one
segment of the indicator must be visible to
ensure full phone functionality while charging.
charge from your computer
You can partially charge your phone's
battery by connecting a Motorola-approved
USB cable from your phone's micro-USB port
to a high power USB connector on a
computer (not a low-power one, such as the
USB connector on your keyboard or
bus-powered USB hub). Typically, USB
high-power connectors are located directly on
your computer.
Note: The phone will be charged at a slower
rate than it is charged with the rapid charger.
Your computer must be turned on, and you
must have correct software drivers installed
on your computer. If the Phone is off when
the USB cable is connected between the
computer and the phone, the phone will
essentials
11
Advertisement
Table of Contents
