Table of Contents
Advertisement
Installing and charging the battery
How to get your mobile charged up.
The battery is not fully charged when
1. Push down the release latch, and slide
you buy your mobile. Before you can
the cover back down to remove it.
use your mobile you need to install
and charge the battery as shown.
Your mobile is designed to be used only
™
with Motorola Original
batteries.
We recommend that you store batteries
in the protective case when not in use.
When you charge the battery, the
battery level indicator in the top
panel of your screen will show how
2. Insert it under the tab at the top of the battery compartment
much of the process is complete.
and push down into position.
Your battery will perform at its
best after several full charge and
discharge cycles.
A battery that has not been used for a
long period of time needs to be
completely discharged by leaving the
mobile turned on and then recharged
2 or 3 times before reaching full
capacity.
1.3
User guide
3. Replace the battery cover and
slide into place until it locks.
4. Plug in the travel charger with the release
tab facing upwards on the mobile. Plug
the charger into an electrical outlet.
When your mobile indicates on screen
that the battery is fully charged
(Charge Complete), press the release
tab and remove the charger.
1
User guide
1.4
Advertisement
Table of Contents
