Yamaha SRX440 1980 Service Manual page 20

1980 SRX440
1. Play
2. Adjuster
3. Lock nut
C. Primary sheave
Refer to "5-1 - B. Primary sheave".
D. Flywheel magento
(For inspection. refer to '7 -1-G. Pulser and
charge coil test" and "7-2-C. Lighting
circuit test'")
1. Install woodruff key.
------'Tln-sfilTI-f1ywheeTbase:··
Flywheel base tightening torque:
. 6 Nm (0.6 m-kg)
Tightening torque:
10 Nm (1.0 m-kg)
E, Water pump
NOTE: - - - - - - - - - - - - -
For inspection, refer to "3-4 Water pump".
1. Install the water pump assembly tem-
porarily.
2. Install the drive water pump pulley with
water pump belt.
3. Install flywheel using rotor holding tool.
NOTE: - - _ - - - _
Make sure woodruff key is properly seated in
keyway of crankshaft. Carefully install fly-
wheel while taking care so it aligns with
woodruff key.
Tool name
Rotor holding tool
Tool No.
..90890-01235
3. Install the starter pulley using rotor
holding tool.
Flywheel nut torque:
73 Nm (7.3 m-kg)
. 4. Adjust ignition timing.
CAUTION: - -.....- - - - - - - .
Whenever the flywheel magneto is re-
moved, ignition timing must be reset.
(Refer to 7-1-C. Ignition timing)
. .5.
Install the crankcase cover.
2-14
Tool name
Rotor holding tool
Tightening torque:
15 Nm (1.5 m-kg)
.
Tool No .
90890-01235