Filling with coolant
►
Fill coolant to the expansion tank until the
MAX-marking
6
►
Close the expansion tank.
►
Warm up the engine. (See chapter 4.2
Operation during the break-in period.)
►
Turn off the engine.
►
Check the coolant level.
CAUTION! Scalding caused by hot steam. Open
expansion tank only with a cold engine.
NOTICE! Danger of overheating caused by a lack
of coolant.
►
When coolant level is below the MIN-
marking
, wait until the engine has
7
cooled down.
►
Refill coolant, until the coolant level is
between the MIN-marking and the MAX-
marking.
NOTICE! Leaks in the hoses due to increased
pressure.
►
When the MAX-marking is exceeded, pump
out excessive coolant with a suction pump.
►
Touch up paintwork defects.
►
Clear the service counter to reset service
light. (See the Textron Motors Diagnostic
Tool manual.)
►
Update the engine control unit calibration.
(See the Textron Motors Diagnostic Tool
manual.)
►
Test-drive the vehicle.
SHB MPE850 Rev F | 408014 | 408090 | 408101 | 408246 |
.
8 Service tasks in the workshop
6
7
8.11 Changing coolant
87