Monitoring Power Over Ethernet Via Cli - Alcatel-Lucent OmniSwitch 6250 Hardware User's Manual

Managing Power over Ethernet (PoE)

Monitoring Power over Ethernet via CLI

To monitor current PoE statistics and settings, use the
output displays a list of all current PoE-capable, along with the following information for each port:
Maximum power available to the port, in milliwatts
•
• Actual power used by the port
Current port status
•
Power priority status
•
• Power on/off status
Aggregate slot and chassis management information is also displayed. This information includes:
Maximum watts available to the corresponding slot
•
• Amount of power budget remaining that can be available for PoE modules
Total amount of power remaining that can be available for additional switch functions
•
When entering the show lanpower command, you must include a valid slot number in the command line
syntax. For example:
-> show lanpower 1
-> show lanpower 1
Port Maximum(mW) Actual Used(mW)
----+-----------+---------------+-----------+---------+------+-------
1 31000
2 31000
3 31000
4 31000
Slot 1 Max Watts 225
1 Power Supplies Available
Note. For detailed information on show lanpower command output, refer to the OmniSwitch CLI Refer-
ence Guide.
OmniSwitch 6250 Hardware Users Guide
lanpower combo-port
Status
0 Undefined
0 Undefined
0 Undefined
0 Undefined
September 2015
Monitoring Power over Ethernet via CLI
command. The command
Priority On/Off Class
Low OFF None
Low OFF None
Low OFF None
Low OFF None
page 6-11