Related Manuals for Kicker KPW2
Summary of Contents for Kicker KPW2
- Page 1 ™ Portable Wireless Speaker | QUICK-START Bocina inalámbrica portátil | GUÍA DE INICIO RÁPIDO Haut-parleur sans fil portable | GUIDE DE DÉMARRAGE RAPIDE...
- Page 2 Contents | Contenido | Contenu IMPORTANT: Fully charge the KPw2 before fi rst use by connecting to power supply for up to 5 hours. Aux Input is only active when 1/8” (3.5mm) stereo cable is connected and no Bluetooth playback is detected.
- Page 3 Controls | Controles | Contrôles LED Status ® Blue Bluetooth Blinking Blue Pairing Green Aux input Blinking Green No input detected...
- Page 4 Connections | Conexiones | Connexions AUX IN INPUT 5V BATTERY STATUS LED (RED) Normal Battery Low Battery 2 intermittent blinks Charging Breathing Finished Charging Solid...
- Page 5 Pairing | Emparejamiento | Jumelage KICKER KPw...
- Page 6 SPECIFICATIONS | ESPECIFICACIONES | CARACTÉRISTIQUES Two 1-3/4” [44mm] Full Range Drivers Two 2” [52mm] Passive Radiators SPEAKERS Dos conductores de amplitud completa de 1-3/4” [44mm] ALTAVOCES Dos radiadores pasivos de 2” [52mm] HAUT-PARLEURS Deux haut-parleurs pilotes complets de 44 mm [1 po. 3/4] Deux haut-parleurs diffuseurs passifs de 52 mm [2 po.] FREQUENCY RESPONSE RESPUESTA DE FRECUENCIA...
-
Page 7: Troubleshooting
1. Check that the battery is fully charged by connecting the KPw2 to a known-good power source. Allow the KPw2 to charge for at least 3.5 hours, then power on the speaker. The battery is full when the battery status LED turns solid RED while charging. -
Page 8: Resolución De Problemas
1. Revise que la batería esté cargada completamente, conectando el KPw2 a una fuente de energía que sepa que funcione correctamente. Deje cargando el KPw2 por lo menos unas 3.5 horas, y luego enciende la bocina. La batería está cargada completamente cuando el LED de estado de la batería esté... -
Page 9: Dépannage
Le KPw2 ne répond plus ou ne s’allume pas : 1. Vérifi ez que la batterie est totalement chargée en reliant le KPw2 à une source d’alimentation sûre. Laissez le KPw2 se recharger pendant au moins 3 heures et demi puis allumez le haut-parleur. La batterie est complètement rechargée quand le LED d’état de la batterie devient ROUGE fi... - Page 10 5. If you think batteries might have been swallowed or placed inside any part of the body, seek immediate medical attention. 6. Use only power supplies provided by KICKER. 7. Unplug the apparatus during lightning storms or when unused for long periods of time.
- Page 11 FCC ID: TQYKPW2 IC ID: 6233A-KPW2 C22.2 No.60065 KPw2-E-07162015...
- Page 12 ©2015 Stillwater Designs...