Lautsprecher Teufel GmbH . ing . We can only accept the return of a device WITH No part of these instructions may be reproduced in any THE ORIGINAL PACKAGING .
AC adapter plug . Then send the device in to our service address . • Never touch the mains adapter with wet hands . • Check the unit regularly for damage . • DecoderStation 5...
. Heat build-up inside the unit can shorten its lifetime . Overview Product contents a 1 x DecoderStation 5 b 1 x remote control (DS 52 RC) c 1 x mains adapter d 2 x battery for remote control Check to be sure •...
Digital audio input jacks for coaxial cables Analogue audio input jacks for television Analogue audio input jacks for CD player Analogue input jacks 5 . 1 audio input jacks 5 . 1 IN 5 . 1 audio output jacks PRE OUT • DecoderStation 5...
Page 7
Select button ◀▶ Navigation buttons FRONT LEFT, Channel select for level adjust- CENTER, ment FRONT RIGHT, REAR LEFT, SUBWOOFER, REAR RIGHT VOL +/– Volume adjust MODE Surround mode selection Power: Turn DecoderStation 5 on or to standby • DecoderStation 5...
• Avoid placing the unit close to sources of heat or in direct sunlight . • Do not place any heavy objects on the DecoderStation 5 or the cables . The signal receiver for the remote control is located at the front of the unit .
Arrange the cables so that they do not pose a trip hazard . Inputs for source devices The DecoderStation 5 offers you an analogue 5 . 1 audio input, two optical and two coaxial digital audio inputs and three analogue stereo audio inputs (TV, CD and AUX) .
13 “ ” again or change the volume . Turning the display panel on/off You can turn the illumination of the display panel 3 on and off with the button 15 “DISPLAY” so it doesn't distract you, e .g . while watching a movie . • DecoderStation 5...
Menu functions You can operate all functions of the DecoderStation 5 via the user menu . To use the menu: • Push the control dial 4 “POWER/SELECT” or the but- ton 19 “OK” . The “MAIN MENU” will appear on the display panel 3 .
System Reset If you are using satellites and subwoofers, you will have to select a crossover frequency in the DecoderStation 5 . This resets the device to the factory default . Otherwise, the sound quality will suffer and the satellites FW Version could be damaged .
• Select the next channel with the navigation buttons 20 “◀/▶” . • To stop the test sound, push the “RETURN” button 16 . We recommend using a Teufel sound-level meter, which you can order on our website in the accessories area . Channel level buttons Here you can increase and decrease the relative volume for each speaker, even during playback .
Connect your 5 . 1 sound card to an ana- sound card is not transmit- surround sound in real-time and issuing it via logue jack of the DecoderStation 5 . ting any multi-channel the sound card's analogue outputs . However,...
*) labelled with: Cd = Cadmium, Hg = Mercury, Pb = Lead Care and cleaning Clean the DecoderStation 5 regularly with a soft, damp Attention Risk of damage! microfibre cloth . Please be absolutely sure to observe the Using the wrong cleaning materials may dam- following notes: age the delicate surface of the case .
Channel Count 2.1 Channel / 5.1 Channel For questions, suggestions or other issues please contact our customer service department: Lautsprecher Teufel GmbH Tel . : 00800 200 300 40 (toll-free) No liability is accepted for the Gewerbehof Buelowbogen - Aufgang D1 Fax: +49 (0)30 - 300 930 930 accuracy of this information .