Storage Of The Hypercut Mower - Quadivator HyperCut RD62 Assembly/Operators/Parts Manual

INFORMATION
Place the new deck drive belt in pulley in the front, then loop it through the idlers on the rear
section of the power unit and attach around the drive clutch pulley.
Re-tension the new deck drive belt by applying tension to the belt through the tensioning bolts at
the rear of the power unit frame. Visually verify the belt is routed correctly between the pulleys,
is not twisted and running straight - then do final tightening with the tensioning bolts.
Replacement of the Deck Belt
Remove the belt by pulling and keeping the tensioner away from the belt and then remove the
belt that has been loosened.
The Deck Belt is spring loaded to maintain consistent deck belt tension! It is not necessary to
remove the springs to remove the belt.
Re-install the Deck Belt by reversing the direction of removal – install on one pulley and route
through the idlers and then "pry" the belt into place with a non-metal pry bar – nylon works well.

5.4 Storage of the HyperCut Mower

If the HyperCut Mower is to be stored for more than 30 days, prepare the unit as follows:
-store the HyperCut mower with the Drive Belt tension "relaxed" and with blades
disengaged to prevent the Drive Belt from being permanently stretched.
If the deck belt needs replacing, at this point in the
disassembly replace the deck belt!
Belt routing shown