Table of Contents
Advertisement
Check the pneumatic wheels on the HyperCut mower daily. They should have 45psi.
Cutting height can be adjusted from 1 – 3.75 inches (25 to 95 mm) to set the cutting height,
operate the RHS Height Control Lever.
On thick springy grass or soft ground, the mower's rollers may sink into the ground giving too
low a cut – adjust the cutting height deck with the Height Control Lever to compensate for the
soft ground conditions.
Use the higher or taller settings for mowing in a rough area or when mowing high grass. Lower
settings should be used only for smooth lawns where short grass is desired.
4.3 Operating Mower
DANGER
Keep the HyperCut Mower engine running at full throttle for best mowing results.
Control forward travel speed by ATV forward speed – DO NOT mow at more than 5 MPH or 8
KPH.
During heavy duty use, operate the machine at a slower speed or go over the area twice.
The mower will not cut cleanly if the ground speed is too high or if the blade speed drops due to
an overload.
IMPORTANT – To prevent the engine from overheating, keep the air inlet screen on
the top of the motor clean at all times!
5. Maintenance
5.1 Service Intervals
Item
Check Point
#
1
Check Mower Blade Wear
2
Ensure Blade Cap Screws are Tight
3
Check all Hardware are Tight
4
Clean Mower Deck
5
Check Drive Belt Tension
6
Check Engine Oil Level
Check Security of Hitch Pin -
7
located on ATV Hitch
To avoid serious injury or death, DO NOT Operate
the mower without discharge deflector properly
bolted in place.
Use Hour Interval (change or
check every interval)
Check Daily
x
x
x
x
x
x
x
50 Hours
Annually
or Weekly
Hide quick links:
Advertisement
Table of Contents
