Table of Contents
Advertisement
Switching on manually:
Switching off manually:
Switching on the engine
heating:
Switching off the engine
heating:
Setting the time:
Programming heating start:
Selecting programmed
switching on time:
10.4
10.4.1
EN
Globetrotter XXL - 11-06 - DET-0047-01
Fig. 69
Operating unit for independent
vehicle heater
Press the button (Fig. 69,7). The heating mode is displayed by the symbol
(Fig. 69,9).
Press the button (Fig. 69,7). The symbol (Fig. 69,9) goes off.
Press switch (Fig. 69,4) down. Engine is preheated.
Press switch (Fig. 69,4) up. Engine stays cold.
Press the button (Fig. 69,2). The time setting is displayed by the symbol
(Fig. 69,8).
Set the time with the buttons (Fig. 69,3 and 6).
Press the button (Fig. 69,5).
Set the switching on time within ten seconds, with the buttons (Fig. 69,3
and 6).
Keep pressing button (Fig. 69,5) until the selected programme number
(Fig. 69,1) appears in the display.
Alde boiler
Never let gas escape unburned due to danger of explosion.
When filling the fuel tank, on ferries or in the garage, never run the boiler
in gas operation. Danger of explosion!
Never use boiler when empty.
If the boiler is not being used, empty it if there is any risk of frost.
Only operate the boiler with the maximum temperature setting if you
require a large quantity of warm water. This protects the boiler against the
build-up of limescale.
Switching the boiler on/off
The boiler is integrated in the hot-water heater. A separate operation is not
possible. For operating the hot-water heater, see section 10.2.
10
Appliances
95
Advertisement
Table of Contents
