Grundig GCI-K0622D Owner's Manual page 54

9.8.6. Manual trigger
In the Manual Trigger setting, the current image(s) or video(s) can be upload to the appointed destination, such as
an FTP site or an E-mail address. The administrator can specify the triggered actions that will take place when
the users switched the Manual Trigger button to <On>. All options are listed as follows.
Manual Trigger :
The default setting for the Manual Trigger function is <Off>. Enable the function by selecting <On>. After the
Manual Trigger function is enabled, click on the Manual Trigger button on the Home page to start uploading data.
Click again to stop uploading.
Triggered Action (Multi-option) :
The administrator can specify alarm actions that will take place at alarm occurrence. All options are listed as
follows.
Triggered Action (Multi-option) :
The administrator can specify alarm actions that will take place at alarm occurrence. All options are listed as
follows.
- Enable Alarm Output:
Select this item to enable the alarm relay outputs.
- IR Cut Filter:
Select the item and the IR cut filter (ICR) of the camera will be removed (on) or blocked (off) when an alarm is
triggered.
Note: The IR Function (Please refer to the section "IR Function") cannot be set as <Auto> mode if this trigger
action is enabled.
- Send Message by FTP:
The Administrator can choose to send an alarm message by FTP when an alarm is detected.
- Send Message by E-Mail:
The Administrator can choose to send an alarm message by E-Mail when an alarm is triggered.
English 52