Desktop Charger; Charging A Battery - Motorola i1000 Getting Started

DESKTOP CHARGER

The NTN8653A Desktop Rapid Charger will charge Motorola
authorized batteries listed on page 59 for the i1000. To charge a
battery, refer to Figure 3 and follow the procedure below:
Front Pocket
LED
Indicators
Pin Connector

Charging a Battery

1. Plug the flat end of the power-supply cord into the receptacle on
the back of the charger.
2. Plug the transformer end of the power-supply cord into any
standard AC wall outlet. The charger performs a quick power-
up self-test, during which the LED indicators will flash once to
indicate a successful power-up.
3. Insert an i1000 portable with an attached battery, into the
charger's front pocket. This is done by inserting the bottom of
i1000 portable onto the pin connector in the bottom of the
charger's front pocket.
4. If the portable is properly seated in the front pocket, the
charger's front pocket LED indicator will light red to indicate
that the battery is being charged. (If a battery is in the rear
pocket and the portable with a battery is inserted into the front
pocket, the rear pocket's LED flashes yellow, indicating that its
battery is waiting to be charged.)
5. The charger has the capability of displaying the battery's charge
status. The indicator will show the following: solid red=1-30%;
solid yellow=31-60%; flashing green=61-90%; solid green=91-
100%.
i1000
Rear Pocket
Power supply cord receptacle
Figure 3: Desktop Rapid Charger
GETTING STARTED
63