Contents Safety Information .......... 2 Getting Started ............3 ....3 Remote Control - 1 ..........6 Connections............7 First Time Installation - USB Connections ....8 TV Menu Features and Functions ......11 General TV Operation .......... 14 Using DLNA Network Service ....... 19 iPlayer Application ..........
Safety Information If there is lightning or storms, or if the TV is not going to be used for a while (e.g. if going away CAUTION on holiday), disconnect the TV set from the mains. The mains plug is used to disconnect RISK OF ELECTRIC SHOCK TV set from the mains and therefore it must DO NOT OPEN...
Getting Started Notifications & Features & Accessories • Headphone connection. Environmental Information • Automatic programming system. This television is designed to consume less energy • Manual tuning. to help save the environment. To reduce energy consumption, you should take the following steps: • Automatic power down after up to six hours. You can use the Power Save Mode setting, located •...
Page 5
Operation with the Buttons on the TV Notification Press button to decrease volume or Manufactured under license from Dolby Laboratories. button to increase volume. Press P/CH + button to TRADEMARK ACKNOWLEDGMENT select the next programme or P/CH - button to select “Dolby”...
Page 6
Teletext Specification Press “ ” button to enter. Press again to activate mix mode. Press once more to exit. Follow the TV Broadcasting PAL B/G D/K K instructions displayed on digital teletext screen. Receiving Channels VHF (BAND I/III) - UHF Digital Teletext (for UK only) (BAND U) - HYPERBAND Press“...
Getting Started Remote Control - 1 1. Source 2. Sleep Timer 3. Internet Portal 4. Play ( in media browser mode ) 5. Programme recording 6. Rapid reverse 7. Mono/Stereo - Dual I-II / Current language (in DVB channels) 8. Green button 9.
Getting Started Connections Connector Type Cables Device NOTE: When connecting a device via the YPbPr or Scart Side AV input, you must Connection use a connection cables (back) to enable connection. See t h e i l l u s t r a t i o n s a b o v e . | Mini Scart To e n a b l e P C a u d i o , y o u Connection...
Getting Started First Time Installation - USB Connections Cable Installation Switching On/Off If you select CABLE option and press OK button on To Switch the TV On the remote control a confirmation message will be Connect the power cord to the 220-240V AC, 50 Hz. displayed.
Page 10
Recording a Programme Note: You cannot use the timeshift fast reverse feature IMPORTANT: When using a new USB hard disk drive, before advancing the playback with the fast forward it is recommended that you first format the disk using option. your TV’s “Format Disk”...
Page 11
Media Browser Menu You can play photo, music, and movie files stored on a USB disk by connecting it to your TV. Connect a USB disk to one of the USB inputs located on the side of the TV. Pressing the MENU button while in the Media Browser mode will access the Picture, Sound and Settings menu options.
TV Menu Features and Functions Picture Menu Contents 3D Settings Press to view 3D settings. You can change the picture mode to suit your preference or requirements. The Picture Mode mode can be set to one of these options: Cinema, Game, Sports, Dynamic and Natural. Contrast Sets the lightness and darkness values of the screen.
Page 13
Sound Menu Contents Volume Adjusts the volume level. Selects the equalizer mode. Custom settings can be made only Equalizer when in user mode. Balance This setting is used for emphasizing left or right speaker balance. Headphone Sets headphone volume. Sound Mode You can select a sound mode (if the selected channel supports).
Page 14
Application Version Displays application version. Hard of Hearing Enables any special feature sent from the broadcaster. Audio description refers to an additional narration track for blind and visually impaired viewers of visual media, including television and movies. You can use this feature, only if the broadcaster supports that additional narration Audio Description track.
General TV Operation Using the Channel List Record / Delete Record Timer The TV sorts all stored stations in the Channel List. You can edit this channel list, set favourites or set After you have selected a programme in the active stations to be listed by using the Channel List EPG menu, press the OK button.
Page 16
exposed to certain conditions, including flashing CAUTION - 3D Images lights or images in TV or video games. • Read these safety instructions carefully to prevent • Sometimes certain symptoms can occur in damage.and ensure your personal safety. unspecified conditions even if you do not have any •...
Page 17
3D Mode Viewing Distance Press the MENU button and select the Picture icon Size using the “ ” or “ ” buttons and press OK. Use “ (inch) ” or “ ” to select 3D settings and press OK to view. Viewing •...
3D Viewing Information - continued • Connect your PC to your modem/router. This can be a wired or wireless connection. HDMI • Connect your TV to your modem/router via an ethernet cable. There is a LAN port at the rear 1080p@24 FP (back) of your TV.
Page 19
IP Address • Use a LAN connection for quicker file sharing between other devices like computers. If an active connection is available, the IP address will • The frequency and channel differ depending on the be displayed on this section. If you want to configure area.
Wait until the IP address is shown on the screen. Connectivity Troubleshooting This means that the connection is now established. To Wireless Network Not Available disconnect from a wireless network press OK. • Ensure that any firewalls of your network allow You can navigate between menu tabs by pressing left/ the TV wireless connection.
Page 21
DLNA Internet Portal DLNA support is only available in the Media Browser You can access PORTAL mode using your TV. To do folder mode. To enable folder mode, go to the Settings this, an active internet connection is required. Follow tab in the main media browser screen and press OK.
iPlayer Application You can access BBC iPlayer using your TV. To do this, an active internet connection is required. (See connecting to a Wired/Wireless Network section to connect your TV to internet). After the connection is established, you can select BBC iPlayer among the portal options.
Internet Browser To use the internet browser, please select the internet browser logo from the portal section. • To navigate the web browser, use the arrow buttons pages and these will take you to the appropriate on the remote control. Press OK to continue. pages.
Remote control - does not operate Software Upgrade • The batteries may be exhausted. Replace the Your TV is capable of finding and updating automatically bateries. via the Aerial/Cable signal or over the Internet. Input sources - can not be selected Software upgrade search via user interface •...
Page 25
• The Select Installation Type screen is displayed. It is possible to choose between Typical, meaning standard installation, or Custom installation. User defined installation allows you to determine languages to be installed and to choose the installation path. 7. Use Typical installation and click the Next button. •...
PC Input Typical Display Modes AV and HDMI Signal Compatibility The following table is an illustration of some of the Source Supported Signals Available typical video display modes. Your TV may not support all resolutions. Your TV supports up to 1920x1200. Index Resolution Frequency...
Important Instruction For your own safety read following instruction carefully before attempting to connect this unit to the mains supply. MAINS (AC) OPERATION The wires in the mains lead are coloured in accordance with the following code : GREEN & FUSE YELLOW (Earth)
Page 29
Product Fiche Commercial Brand: FINLUX Product No. 10087582 Model No. 47F9076-T Energy efficiency class Visible screen size 47 inches 120 cm (diagonal, approx.) (inch/cm) On mode average power consumption (Watt) Annual energy consumption (kWh/annum) Standby power consumption (Watt) Off mode power consumption...
Need help?
Do you have a question about the 47F9076-T and is the answer not in the manual?
Questions and answers