Product Specific & Important Safety Information; Fireplace Certification; Non-Combustible Materials; Combustible Materials - Heatilator A36R Installation Manual

Hide thumbs Also See for A36R:
Table of Contents

Advertisement

1
Product Specific & Important Safety Information
A. Fireplace Certification
This fireplace system has been tested and listed in accor-
dance with UL 127 and ULC-S610 standards by Under-
writers Laboratories Inc. for installation and operation in
the United States and Canada.
This fireplace may be installed in sleeping rooms. This
is not approved for installation in manufactured homes.
If installed with a gas log set, provisions for the National
Fuel Gas Code must be met.
This fireplace has been tested and listed for use with
the optional components specified in this manual. These
optional components may be purchased separately and
installed at a later date. An outside air kit, gas insert, gas
log set or gas log-lighter should be installed at the time of
fireplace installation.
Heatilator is a registered trademark of Hearth & Home
Technologies.
WARNING! Risk of Fire! Hearth & Home Technologies
disclaims any responsibility for, and the warranty and
agency listing will be voided by the following actions.
DO NOT:
• install or operate damaged fireplace
• modify fireplace
• install other than as instructed by Hearth & Home
Technologies
• operate the fireplace without fully assembling all
components
• overfire
• install unvented gas log set
• install any component not approved by Hearth & Home
Technologies
• install parts or components not Listed or approved
Improper installation, adjustment, alteration, service or
maintenance can cause injury or property damage. For
assistance or additional information, consult a qualified
installer, service agency or your dealer.
Heatilator • A36/42R, A36/42RH • Installers Manual • 4017-259 • Rev I • 06/29/15
4
B. Non-Combustible Materials
Materials which will not ignite and burn, composed of
any combination of the following:
-
Steel
-
Brick
-
Concrete
-
Glass
Materials reported as passing ASTM E 136, Standard
Test Method for Behavior of Metals, in a Vertical Tube
Furnace at 750° C
C. Combustible Materials
Materials made of or surfaced with any of the following
materials:
-
Wood
-
Plant fibers
-
Plywood/OSB
Any material that can ignite and burn; flame proofed or
not, plastered or un-plastered
- Iron
- Tile
- Slate
- Plasters
- Compressed paper
- Plastic
- Sheet rock (drywall)

Advertisement

Table of Contents
loading

This manual is also suitable for:

A36rhA42rA42rh

Table of Contents