Install Hood; Install Control Heat Shield; Close The Screen Assembly - Heatilator NNXT4236IF Installation Manual

N. Install Hood
• Locate the four screws just inside the upper section of
the appliance.
• Slide the hood into position under the screw heads.
• Tighten the four screws. See Figure 11.15.
Figure 11.15 Installing Hood
O. Install Control Heat Shield
The control heat shield MUST be placed over the control
plate before operating the appliance. Not doing so may
result in overheating the controls on the plate.
• Verify that the control heat shield is installed and legs
are on bottom pan of appliance. See Figure 11.16.
Control Heat Shield in Place
Figure 11.16 Control Heat Shield - Installed
• Make sure all wires are under the top of the control heat
shield and that there are no wires pinched between legs
and the bottom pan.
46 Heatilator • NNXT4236IF, NNXT4236ILF, NNXT3633IF, NNXT3633ILF Installation Manual • 4055-980 Rev. D • 9/15
P. Close the Screen Assembly
• Make sure the screen magnetic touch latches are in the
open position. See Figure 11.17.
• Hang the screen on the shoulder screws in the columns.
See Figure 11.18.
Figure 11.17 Magnetic Touch Latch Open
Hang Screen on Shoulder Screws
Figure 11.18 Hang Screen
Open