Heatilator NNXT4236IF Installation Manual page 17

• Remove the side refractory:
- Gently raise the front of the top refractory.
- Lift the side piece up slightly and then out.
Lift top refractory
and hold in place
Figure 4.11b Remove Side Refractory
• Remove top refractory:
- Lower towards side removed in previous step.
- Gently twist out.
Lower & twist; pull out
Figure 4.11c Remove Top Refractory
Heatilator • NNXT4236IF, NNXT4236ILF, NNXT3633IF, NNXT3633ILF Installation Manual • 4055-980 Rev. D • 9/15
Pull side refractory
forward & out
• Remove two screws from fi rebox top.
• Using these screws and the same holes, install the top
vent fl ue baffl e.
- The fl ue baffl e will be turned to install below the level
of the fi rebox top for 12-30 ft vertical runs of vent.
See Figure 4.11d.
- The fl ue baffl e will be turned to install inside the fl ue
for vertical vent runs of 31-60 ft. See Figure 4.11e.
Place flue visor,
reinsert screws
Figure 4.11d 12-30 ft Vertical Run
Place flue visor,
reinsert screws
Figure 4.11e 31-60 ft Vertical Run
• Reinstall Refractory:
- Replace top refractory.
- Lift top refractory and slide side refractory back into
position.
- Replace bottom retainer.
17