Desa LDL3924NR Owner's Operation And Installation Manual page 19

OPERATION
Continued
. Note: If pilot does not stay lit, contact a
qualified service person or gas supplier
for repairs. Until repairs are made, light
pilot with match. To light pilot with match,
see.Manual Lighting Procedure..
.. Keep.control.knob.pressed.in.for.30.sec-
onds after lighting pilot. After 30 seconds,
release.control.knob.
•.If.control.knob.does.not.pop.out.when.
released, contact a qualified service
person.or.gas.supplier.for.repairs.
. Note: If pilot goes out, repeat steps 4
through.8.
10..Slightly. push. in. and. turn. control. knob.
counterclockwise.
tion.
11..Press.the.on/off.key.on.the.remote.control.
to.turn.on.appliance.main.burner..Wait.at.
least. 5. seconds. before. setting. desired.
flame height.
1..Press.the.up.or.down.key.until.the.small.
triangle is to the left of large flame icon
at the top of LCD display (see Figure 29,
page.0)..Press.the.left.or.right.key.to.set.
the desired flame height.
13. Replace control cover log (see Figure 25,
page.18).
CAUTION: Do not try to ad-
just heating levels by using the
equipment shutoff valve.
Note: The pilot flame on natural gas units will
have a slight curve, but flame should be blue
and.have.no.yellow.or.orange.color.
Pilot.Burner
Figure 27 - Pilot (Propane/LP)
Pilot.Burner
Figure 28 - Pilot (Natural)
111515-01J
.to.the.ON.posi-
Ignitor.
Electrode
Ignitor.
Electrode
www.desatech.com
TO TURN OFF GAS
TO APPLIANCE
Shutting Off Heater
Press.on/off.key.on.remote.control.and.turn.
control. knob. clockwise.
position (see Figure 26, page 18).
Shutting Off Burners Only (pilot stays lit)
Press.the.on/off.key.on.remote.control.or.turn.
control. knob. clockwise.
position.
MANUAL LIGHTING
PROCEDURE
1.. Follow.steps.1.through.7.under.Lighting
Instructions, page 18.
.. Depress.control.knob.and.light.pilot.with.
match..
3.. Keep.control.knob.pressed.in.for.30.sec-
onds after lighting pilot. After 30 seconds,
release.control.knob..Now.follow.steps..
through.11.under.Lighting Instructions.in.
column.1.
HAND-HELD
REMOTE OPERATION
NOTICE: You must light the pilot
before using the hand-held re-
mote control unit. See Lighting
Instructions, page 18.
When.the.appliance.and.the.remote.control.
are switched off, the house icon with the room
temperature.will.be.displayed..When.the.re-
mote control is turned on, other icons will be
visible.and.the.main.burner.of.the.appliance.
will.turn.on.
1.. Turn.control.knob.clockwise.
ON position (see Figure 26, page 18).
.. Press. the. ON. button. on. remote. control.
(see Figure 29, page 20). Wait 5 seconds
to.send.a.command.to.appliance.
Note:.An. acoustic. signal. will. be. heard. that.
confirms the reception of the command sent
from.the.remote.control.
. to. the. OFF.
. to. the. PILOT.
.to.the.
1