Desa LDL3924NR Owner's Operation And Installation Manual page 18

OPERATION
Continued
LIGHTING
INSTRUCTIONS
WARNING
• If fireplace has glass doors,
never operate this heater with
glass doors closed. If you op-
erate heater with doors closed,
heat buildup inside fireplace
will cause glass to burst. Make
sure there are no obstructions
across opening of fireplace.
• You must operate this heater
with a fireplace screen in
place. Make sure fireplace
screen is closed before run-
ning heater.
NOTICE: During initial operation
of new heater, burning logs will
give off a paper-burning smell.
Orange flame will also be pres-
ent. Open damper or window to
vent smell. This will only last a
few hours.
Note:.Home.owners.generally.prefer.to.oper-
ate. their. heater. with. the. chimney. damper.
closed..This.will.put.all.the.heat.into.the.room..
However, there may be times you will desire
the full flames of the highest heat setting but
will find the heat output excessive. You can
open.the.chimney.damper.(if.you.have.one).
fully.or.partially.to.release.some.of.the.heat.
WARNING: Damper handle
will be hot if heater has been
running.
WARNING: Burners will
come on automatically within
one minute when the control
valve is in the ON position after
the pilot is lit.
18
1.. STOP!. Read. the. safety. information. on.
page.17.
.. Make.sure.equipment.shutoff.valve.is.fully.
open.
3.. Remove.control.cover.log.(see.Figure.5).
4.. Set.remote.selector.switch.in.the.AUTO.
position.(see.Figure.6)..
5.. Press. in. and. turn. control. knob. clockwise.
6. Wait five (5) minutes to clear out any gas.
Then smell for gas, including near the
floor. If you smell gas, STOP! Follow "B"
in the safety information, page 17. If you
don't smell gas, go to the next step.
7.. Press. in. and. turn. control. knob. counter-
clockwise.
Press in control knob for five (5) seconds
(see.Figure.6)..
. Note:. You. may. be. running. this. heater.
for the first time after hooking up to gas
supply. If so, the control knob may need
to.be.pressed.in.for.30.seconds.or.more..
This.will.allow.air.to.bleed.from.the.gas.
system.
8. With control knob pressed in, press and
release.ignitor.button..This.will.light.pilot..
The.pilot.is.attached.to.the.rear.of.the.front.
burner. If needed, keep pressing ignitor
button.until.pilot.lights.
Control.Cover.Log
Figure 25 - Control Knob (Shown in
the OFF Position) and Ignitor Button
AUTO
Remote.Selector.Switch
Figure 26 - Remote Selector Switch,
Control Knob and Ignitor Button
www.desatech.com
.to.the.OFF.position.(see.Figure.6).
. to. the. PILOT. position..
Control.Knob
Location
MAN
Ignitor.Button
Control.Knob
Ignitor.
Button
111515-01J