Additional Functions; Buzzer - Miele G 4170 SCVI Operating Instructions Manual

Operation

Additional functions

Buzzer

An audible tone sounds at the end of
the programme or if there is a fault.
You will hear the buzzer at the end of
the programme. It will sound four times
in bursts of three beeps with a
noticeable pause (approx. 15 seconds)
in between. The buzzer will continue to
sound for up to an hour if you do not
switch the dishwasher off or open the
door.
In the event of a fault, the buzzer will
sound four times in bursts of three
beeps with only a very short pause in
between for up to two minutes if you do
not switch the dishwasher off, open the
door or correct the fault.
The buzzer is activated as standard at
the factory.
You can deactivate the buzzer at the
end of a programme if you wish. The
buzzer which sounds when there is a
fault cannot be deactivated.
^ Open the door.
^ Switch the dishwasher off with the Off
button V.
^ Press the programme selector button
;? in, and whilst holding it in
switch the dishwasher on using the
On button U .
Keep the programme selector button
;? pressed in until the lower right
hand programme indicator comes
on.
If this does not happen, start the
procedure from the beginning again.
34
^ Press the programme selector button
;? four times briefly.
The Inlet/drain check light 2/2 will
flash briefly four times at intervals.
The upper right hand programme
indicator light shows whether the
buzzer at the end of the programme is
activated or deactivated.
– If the upper right hand programme
indicator is flashing: the buzzer is
activated
– If the upper right hand programme
indicator is not lit up: the buzzer is
deactivated
^ If you want to change the setting,
press the programme selector button
;? for at least one second until the
Inlet/drain check light 2/2 comes
on.
^ Press the programme selector button
;? briefly.
The setting is now stored in memory.
^ Switch the dishwasher off with the Off
button V.