Preset Memories - Panasonic AW-HE60SE Operating Instructions Manual

Preset memories

This unit enables up to 100 settings for the camera direction
(panning and tilting), zoom, focus, iris, gain and white
balance to be registered in its preset memories, and called.
However, the number of settings that can be registered and
called depends on the type of wireless remote control or
controller that is used for operation.
p  The focus and iris operating modes (manual and auto
settings) are not registered.
The current focus and iris values are registered.
p  The focus and iris values can be recalled only when the
manual settings are applicable.
p  AWB A, AWB B or ATW is registered as the white balance
setting. The values selected when AWB was established
are recalled as the adjustment values of AWB A or
AWB B.
p  The AWB Mode (ATW, AWB A and AWB B) stored using
the AW-RP655 are recalled only when the AW-RP655 is
connected.
Notes
p  When there is a large difference in the environmental
temperature between the time of registration and the
time the setting is called, displacement of the preset
position may occur.
p  If displacement occurs, perform registration again.
p  While preset settings are being called, it is not
possible to perform manual operations such as
panning, tilting, zooming or iris adjustments.
p  If, when one set of preset settings has been called,
another set of preset settings is then called, the first
set of preset settings which have been called will take
precedence.
20
When performing the operations
using the wireless remote control
Twelve settings (preset No.1 to No.12) can be registered and
called using the wireless remote control.
The [1] to [12] buttons correspond to the unit's preset
memories No.1 to No.12.
q Registering the settings in the preset memories
p
1
Display the picture to be shot on the monitor.
Operate the pan, tilt or zoom buttons to determine the
camera angle.
Adjust the focus, iris, gain and white balance if they need
to be adjusted.
2
While holding down the [PRESET] button, press
the button corresponding to the preset memory
number.
p  If a preset memory number with an already registered
setting has been selected, the existing setting will be
erased and replaced with the new one.
q Calling the settings of the preset memories
p
1
Press the button in which the preset memory
setting has been registered.