Reprogramming A Single Homelink Button; Erasing Homelink Buttons - Kia 2016 Optima Owner's Manual

Reprogramming a single
®
HomeLink button
To program a new device to a previ-
ously trained HomeLink ®
low these steps:
1. Press and hold the desired
HomeLink ® button.
release until step 4 has been com-
pleted.
2. When the indicator light begins to
flash slowly (after 20 seconds),
position the handheld transmitter 1
to 3 inches away from the
®
HomeLink surface.
3. Press and hold the handheld
transmitter button. The HomeLink
indicator light will flash, first slowly
and then rapidly.
4. When the indicator light begins to
flash rapidly, release both buttons.
5. Press and hold the just-trained
®
HomeLink button and observe
the red Status Indicator LED. If the
indicator light stays on constantly,
programming is complete and
your new device should activate.
Erasing HomeLink
Individual buttons cannot be erased.
However, to erase all three pro-
button, fol- grammed buttons:
1. Press and hold the two outer
HomeLink
Do NOT cator light begins to flash-after 20
seconds.
2. Release both buttons. Do not hold
for longer than 30 seconds.
The Integrated HomeLink
Control System is now in the training
(learn) mode and can be pro-
grammed at any time following the
appropriate
® Programming sections above.
®
buttons
® buttons until the indi-
® Wireless
steps in the
Features of your vehicle
FCC ID: NZLZTVHL3
IC: 4112A-ZTVHL3
Pursuant to Code of Federal
Regulations, Title 47, Part 15
("FCC Rules")
Operation is subject to the following
two conditions:
1. This device may not cause harmful
interference, and
2. This device must accept any inter-
ference received, including inter-
ference that may cause undesired
operation.
4 59