Replacing The Display Assembly; Procedure; Post-Requisites - Dell Inspiron 17 5000 Series Service Manual

Replacing the display assembly

WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before working inside your
computer, follow the instructions in
computer. For more safety best practices, see the Regulatory
Compliance home page at www.dell.com/regulatory_compliance.

Procedure

1 Place the palm-rest assembly at the edge of a table with the display
hinges facing up.
2 Align the screw holes on the display hinges with the screw holes on the
palm-rest assembly.
3 Replace the screws that secure the display hinges to the palm-rest
assembly.
4 Close the display and turn the computer over.
5 Route the antenna cable through the routing guides on the palm-rest
assembly.
6 Adhere the tapes that secure the display cable and the antenna cables to
the palm-rest assembly.

Post-requisites

1 Replace the
2 Replace the
3 Replace the
4 Replace the
5 Follow the procedure from step 3 to step 8 in
base".
6 Follow the procedure from step 4 to step 7 in
drive".
7 Replace the keyboard.
8 Replace the
9 Replace the
10 Follow the procedure from step 4 to step 6 in
power-adapter port.
system board.
heat-sink assembly.
I/O board.
memory modules.
wireless card.
computer. After working inside your
After working inside your
"Replacing the computer
"Replacing the optical
"Replacing the hard drive".
77