Rheem 743 series Owner's Manual And Installation Instructions page 21

INSTALLATION
TAP INSTALLATION
There are currently two tap styles available, the 743 Series (Aqua) and the 7431
Series (Azure). Installation information for the Azure model is provided with the Azure
Tap.
743 SERIES RHEEM TAP
To install the Rheem Tap onto a bench, a 35mm diameter hole must first be cut in
the bench top in the desired location (ensure that all burrs and sharp edges are
removed prior to fitting the tap). Next remove the adhesive backing from the
mounting gasket and stick the gasket to the underside of the bench. The tap (minus
the clamp washer, mounting gasket and mounting nut) is then lowered through the
hole. Place the clamp washer and clamp over the threaded clamp rod and screw on
the mounting nut. Only tighten the mounting nut enough to loosely secure the tap,
and ensure the tap is pointing in the preferred direction for usage. Ensure the tap
communications lead is free to move and not pinched between the bench and the
clamp. For ease of installation, cut the threaded clamp rod to the appropriate length
so the mounting nut can be tightened with a screw driver.
TAP EXTENSION KIT
Please refer to Installation Instructions supplied with kit.
Rheem Tap installation
Clamp washer
21
Rheem New Zealand Ltd 743 Series BWU Document #: 318489B