Table of Contents
Advertisement
To Switch Heating Zones On
When the mains power supply is switched on, the buzzer beeps once
and all the indicators light up for 1 second, then go out. This indicates
that the ceramic hob has entered standby mode.
Touch the ON/OFF
control, all the indicators show "-".
Place a suitable pan on the cooking zone that you wish to use (see
"Efficient Use of Your Hob" section for selection of suitable pans).
Ensure the bottom of the pan and the surface of the cooking zone are
clean and dry.
Touch the heating zone selection control that corresponds to the
zone where the pan is placed (for example back
).
Select a heat setting by touching the
or
controls. You may
select any power level from "1" to "9".
If you don't choose a heat setting within approx. 1 minute, the ceramic
hob will automatically switch off.
You can change the heat setting at any time during cooking. By
holding down either of these controls, the power level will adjust up
or down.
To use more than one heating zone, touch the control for the next
one you want to use, then select the power level for that (as above).
The timer display will show the time remaining until the automatic
shut-off.
7
Advertisement
Table of Contents
