Important Safety Instructions For Use Of The Battery And Battery Charger - Hitachi DS 13DV2 Instruction Manual And Safety Instructions

AC Input Rating Amperes*
Equal to or
greater than
0
2
3
* If the input rating of a battery charger is given in watts rather than in amperes,
the corresponding ampere rating is to be determined by dividing the wattage
rating by the voltage rating–for example:
9. Do not operate battery charger with damaged cord or plug-replace them
immediately.
10. Do not operate battery charger if it has received a sharp blow, been dropped,
or otherwise damaged in any way; take it to a qualified serviceman.
11. Do not disassemble battery charger; take it to a qualified serviceman when
service or repair is required. Incorrect reassembly may result in a risk of electric
shock or fire.
12. To reduce risk of electric shock, unplug charger from receptacle before
attempting any maintenance or cleaning. Removing the battery will not reduce
this risk.
IMPORTANT SAFETY INSTRUCTIONS FOR USE OF THE
BATTERY AND BATTERY CHARGER
You must charge the battery before you can use the cordless driver drill. Before using
the model UC 12YD battery charger, be sure to read all instructions and cautionary
statements on it, the battery and in this manual.
REMEMBER: USE ONLY HITACHI BATTERY TYPES EB7 SERIES, EB9 SERIES, EB12
SERIES. OTHER TYPES OF BATTERIES MAY BURST AND CAUSE INJURY!
Follow these instructions to avoid the risk of injury:
WARNING:
8
RECOMMENDED MINIMUM AWG SIZE FOR
EXTENSION CORDS FOR BATTERY CHARGERS
but less
than
2
3
4
1250watts
125 volts
Improper use of the battery or battery charger can lead to
serious injury. To avoid these injuries:
Table 1
AWG Size of Cord
Length of Cord, Feet (Meter)
25 (7.5) 50 (15)
18
18
18
= 10 amperes
100 (30) 150 (45)
18 18
18 16
18 16
16
14
14