Table of Contents
Advertisement
GETTING STARTED
Battery setup
1.
Remove the battery compartment cover on the handset, insert the battery,
plug the cord into the jack (inside the compartment) and replace the cover.
2.
Set the handset RINGER switch to ON, and place handset in the base.
Slide down the
battery cover
Connecting the base unit and charging the handset
1.
Plug the AC adaptor into the power DC 9V jack
on the back of the base. Plug the other end
into a wall outlet.
2.
Set the base on a desk on tabletop and place
one handset in the base unit.
3.
Make sure that the CHARGE/IN USE LED
illuminates.
Connecting the charger and charging the handset
(For CLT-U12, CLT-U22 , CLT-U32)
1.
Plug the AC adaptor into the power DC 9V jack
on the back of the charger. Plug the other end
into a wall outlet.
2.
Place another handset in the charger and make
sure that the CHARGE LED illuminates.
Note:
• Charge your handset at least 12
hours before plugging into the phone line.
• Charge the handset for 12 continuous hours prior to first use. The
initial battery charge is important for best performance.
• It is normal for the handset and base to get warm when the
handset is charging in the base.
Caution: Use only the Sanyo AC adaptor that is supplied with this phone.
Using another AC adaptor may damage the phone.
Place the battery
Plug the wire
in the slot
into the jack
6
Slide up the
battery cover
Advertisement
Table of Contents
