Connecting The Power; Connecting The Water Supply - Dacor Discovery series Installation Instructions Manual

Connecting the Power

1. Unwind the power cord and connect it directly to the
electrical outlet.
2. Make sure the appliance is
in Stand-by mode (Stand-
by is flashing on the control
panel display) and that all
lights are off. If the unit is
not in Stand-by mode, touch the ON/OFF key to turn it
off.
3. Also make sure the ICE light on the control panel is off. If
it is on, touch the ICE key to turn it off.

Connecting the Water Supply

Units with grill on bottom:
1. Connect one end of a 1/4 inch O.D. polyethylene water
line to the household water supply valve.
2. Hold the other end of the water line over a bucket. Turn
on the water valve to flush out impurities and air. When
the water is clear, turn off the valve.
3. Connect the water supply fitting to the back of the
refrigerator as shown below. Make sure it is tightened
firmly into place, but do not overtighten.
4. Insert the end of the water line into the self locking water
supply fitting as shown below. Push in until it stops.
Back of
unit
Water
supply fitting
5. Turn on the water valve and check for leaks. Tighten
connections as necessary.
Units with grill on top:
1. Reach under the bottom front of the unit and connect
the water supply fitting to the water supply connection,
as shown below. Tighten it firmly into place, but do not
overtighten.
2. Connect one end of a 1/4 inch O.D. plastic water line to
the household water supply valve.
Front of unit
Water supply
connection
16
Installation Instructions
Water
line
3. Insert the water supply line into the water connection
access hole on the back of the unit as shown.
4. Reach through the opening on the bottom front of the
unit, and pull the end of the water line out of the front.
Hold it over a bucket. Turn on the water valve and flush
out impurities and air. When the water is clear, turn off
the valve.
5. Insert the end of the water line into the self locking
water supply fitting as shown directly below. Push it
until the line stops.
6. Turn the water valve ON and check for leaks. Tighten
connections as needed.
Water
line
Water line:
bottom grill
models
Water line: top
grill models
W
E = Electrical Connection
Utility Connections (Top View)
Water connection
access hole
Back of unit
Front of
unit
Power
W E
W = Water supply connection
E W
cord