Setting Slave Flash Di700A - Nissin Di700A Instruction Manual

Setting slave flash Di700A

Switch Di700A on and while the ready lamp is on, rotate the dial
and press Set button to select desired mode.
When flash is set to SD or SF mode, the of flash power level is
indicated by the lighted LED's. Rotate the dial to select different
flash power levels of 1/128 – 1/64 – 1/32 – 1/16 – 1/8 – 1/4 – 1/2
– 1/1 (Full) power.
The power you selected is memorized and remains unchanged.
When the flash is set to the Wireless mode, the power level will be
controlled by the Master flash. The remote works on all channels
and with group A/B/C.
Set slave flash at any place and direct the flash head as you
desire. Slave sensor may not respond to the master flash in a
poor sensing situation such as extremely bright condition.
Use the flash stand included. Place Di700A on to the flash
stand which can be placed either on a flat surface, or on the
tripod by the screw.
NOTE
Metal type accessory shoe is not recommended since it may give electric
damage on the electrical contact of the flash hotshoe.
14