Setting Slave Flash Di700 - Nissin Di700 Instruction Manual

Setting slave flash Di700

Switch Di700 on and while the ready lamp is on, rotate the dial
and press Set button to select desired mode.
When flash is set to SD or SF mode, the of flash power level is
indicated by the lighted LED's. Rotate the dial to select different
flash power levels of 1/128 – 1/64 – 1/32 – 1/16 – 1/8 – 1/4 – 1/2
– 1/1 (Full) power.
The power you selected is memorized and remains unchanged.
When the flash is set to the Wireless mode, the power level will be
controlled by the Master flash. The remote works on all channels
and with group A/B/C.
Set slave flash at any place and direct the flash head as you
desire. Slave sensor may not respond to the master flash in a
poor sensing situation such as extremely bright condition.
Use the flash stand included. Place Di700 on to the flash stand
which can be placed either on a flat surface, or on the tripod by
the screw.
NOTE
Metal type accessory shoe is not recommended since it may give electric
damage on the electrical contact of the flash hotshoe.
13