Panasonic CF-37 series Reference Manual page 7

Touch Pad
(Advanced)
Function
Pan*
Scroll in various directions of a
document
Zoom*
Magnify/reduce the display of a
document.
Data Zoom*
Display or hide a document, or
perform operations to return to or
proceed with Internet Explorer.
CAUTION
When an external mouse or trackball with additional functions (e.g., wheel func-
tion) is connected, a part or all of the additional functions may fail to operate. To
use these additional functions, install the driver or application software of the
external device by following the procedure below. However, once the driver or
application software is installed, touch pad functions (e.g., auto scroll) may not
operate even if the touch pad is enabled (see the procedure for "When you want
to re-enable the touch pad.").
1 Power off your computer (
the external mouse or trackball device to the computer.
2 Turn the power on and run the Setup Utility (
set [Touch Pad] to [Disable] and close the Setup Utility.
3 Following the operating instructions for the connected external mouse, install
the necessary driver.
When you want to re-enable the touch pad;
1 In [Start] - [Settings] - [Control Panel] - [System] - [Device Manager], when an
external mouse or trackball device is displayed in [Mouse], press [Remove] to
delete it, and then press [OK] to confirm the deletion.
2 Power off your computer (
the external mouse or trackball device.
3 Turn the power on and run the Setup Utility (
set [Touch Pad] to [Enable] and close the Setup Utility.
4 Confirm whether [Alps GlidePoint] exists in [Mouse] (in [Control Panel] - [Sys-
tem] -[Device Manager]).
It is possible that no input is accepted from the touch pad while typing is being
performed. To change the settings, add the check mark for [T ap off when typing]
in [Start] - [Settings] - [Control Panel] - [Mouse] - [Tapping]. (
Touch Pad Operation
Operate while holding down the two buttons.
Ctrl +
Shift +
*
Indicates that the movements will differ depending on the application.
"Starting Up/Shutting Down") and connect
"Starting Up/Shutting Down") and remove
Magnify
Reduce
page 47). In [Main] menu,
page 47). In [Main] menu,
page 10)
(To next page)
7