Maintenance - Shark Rocket HV319Q Instructions Manual

MAINTENANCE

To keep your vacuum's suction power optimal, follow these instructions.
Make sure unit is off and cord unplugged.
EMPTY THE DUST CUP
1 Hold dust cup over a trash bin and press the EMPTy
button on the front of the dust cup. The bottom lid
will open, allowing the debris to fall out.
OR
2
Remove the dust cup from the handheld vacuum by
squeezing the two DUST CUP RELEASE buttons on both
sides of the base at the same time and pulling it out.
Hold dust cup over a trash bin and press the EMPTy
button on the front of the dust cup. The bottom lid
will open, allowing the debris to fall out.
TO CHECK FOR BLOCKAGES, REMOVE AND INSPECT:
1
Turn off and unplug handheld vacuum.
OR
Empty
NOTE: Clean the dust screen inside the dust cup
as required.
3 Once dust cup is empty, close the bottom lid and
insert dust cup back into handheld and you will hear it
click into place.
NOTE: Empty dust cup when debris hits the MAX
fill line.
2
Check all dust cup intake openings.
Empty
1. 8 0 0 . 7 9 8 . 7 3 9 8
Monthly
Post-Motor filter
(1084FTV320)
CLEAN THE FILTERS
1 Access the Pre-Motor foam and felt filters by lifting
the latch on the top of the handheld vacuum. Remove
and hand wash them every month. Let air dry
completely before replacing. Tap loose dirt off filters
between washes as needed. Insert the felt filter first
and then place the foam filter on top of it.
2 Access the Post-Motor filter under the handle.
Remove and hand wash once a year. Let air dry
completely before replacing.
3
Check both sides of the flexible hose attachment for
blockages.
Pre-Motor filters
(1080FTV320)
Foam
Felt
7