Operations; Basic Operations - Clarion DB165 Owner's Manual

·B. OPERATIONS
Note:
Be sure to read this chapter referring to the front diagrams of
chapter
"2.
CONTROLS" on page
3
(unfold).
Basic Operations
Be sure to lower the volume before
switching off the unit power or the ignition
key. The unit remembers its last volume
setting. If you switch the power off with the
volume up, when you switch the power back
on, the sudden loud volume may hurt your
hearing and damage the unit.
Turning on/oft the power
Note:
• Be careful about using this unit for
a
long time
without running the engine. If you drain the car's
battery too far, you may not be able to start the
engine and this can reduce the service life of the
battery.
1. Press the [SRC] button.
2. The illumination and display on the unit light
up. The unit automatically remembers its last
operation mode and will automatically switch
to display that mode.
3. Press and hold the [SRC] button for 1 second
or longer to turn off the power for the unit.
Selecting a mode
1. Press the [SRC] button to change the
operation mode.
2. Each time you press the [SRC] button, the
operation mode changes in the following
order:
Radio mode
~
CD mode
~
Radio mode...
Note:
• If the CD mode is selected when no disc is
inserted, the display shows "NO DISC".
Adjusting the volume
Turning the [ROTARY] knob clockwise
increases the volume; turning it
counterclockwise decreases the volume.
*
The volume level is from 0 (minimum) to 33
(maximum).
Switching the display
Press the [D] button to select the desired display.
Each time you press the [D] button, the display
switches in the following order:
Main display
~
Clock display
~
Main display...
Setting the Z-Enhancer
This unit are provided with 3 types of sound tone
effects stored in memory. Select the one you prefer.
*
The factory default setting is ''Z-EHCR OFF".
1. Each time you press the [Z] button, the tone
effect changes in the following order:
"Z-ENHANCER 1" (bass emphasized)
~
"Z-ENHANCER 2" (treble emphasized)
~
"Z-ENHANCER 3" (bass and treble
emphasized)
~
"Z-EHCR OFF" (no sound
effect)
~ "Z-ENHANCER 1"...
Audio Mode Adjustments
1. Press the [A-M] button to select the
adjustment mode. The mode switches as
follows each time the [A-M] button is pressed:
BASS ~ TREB ~ BAL ~ FAD ~
Previous
mode
*
When the Z-Enhancer function is turned on
BASS (bass) and TRE (treble) cannot be '
selected.
2. Turning the [ROTARY] knob to adjust the
selected audio mode.
BASS (bass): Adjustment range: -7 to +7
TREB (treble): Adjustment range: -7 to +7
BAL (balnce): Adjustment range: L13 to R 13
FAD (fader): Adjustment range: F12 to R12
3. When the adjustment is complete, press the
[A-M] button several times until the function
mode is reached.
*
The display returns to the previous mode 7
seconds after the adjustment.
Adjusting MAGNA BASS EXTEND
The MAGNA BASS EXTEND does not adjust the
low sound area like the normal sound adjustment
function, but emphasizes the deep bass sound
area to provide you with a dynamic sound.
*
The factory default setting is off.
1. Press the [M-B] button to turn on or off the
MAGNA BASS EXTEND effect. "M-B EX"
lights in the display on or off.
Turning the screen saver function
on
or oft
This unit is provided with the screen saver
function.
8
08165