Panasonic Toughbook CF-50 Series Reference Manual page 24

CD Drive
Setting a Disc
Title-side up
Center Holder
Eject Button
Information for the DVD-ROM Drive
1
Turn your computer on
2
Press the disc eject button and slowly pull out the tray
3
Place the disc securely on the center holder
4
Close the tray
CAUTION
Do not apply excessive force to the tray in the open position, doing so could
damage the tray.
Power-saving Mode
If the CD drive has not been accessed within 90 seconds, the drive motor will automati-
cally shut down to reduce the power consumption. When the CD drive is accessed
once again, the power of the drive motor is turned on. However, approximately 30
seconds are required until data is actually read from the disc.
NOTE
If the vibration of the CD drive is excessive, set [CD Drive Speed] to [Low] in the
Setup Utility.
For AutoPlay CDs:
• If an AutoPlay CD does not start after the computer resumes from the standby
or hibernation mode, we recommend reinserting the CD again after a 15-sec-
ond wait.
• An AutoPlay CD may start during the access of a file.
The playback of CDs containing moving pictures (Video CDs, CDs including MPEG
data, etc.) may not be smooth.
To play DVD-Video or MPEG2 files, install the DVD playback software (included).
For information on how to install the software, refer to the instructions of the software
( "WinDVD").
The region code has been set to the following:
<For U.S.A. and Canada> Set to "1"
<For Europe>
Use of another region code or alteration of the region code invalidates the warranty.
For more information, contact Panasonic Technical Support.
If commercially available DVD playback software asks you the region code, set to the
following:
<For U.S.A. and Canada> Set to "1"
<For Europe>
(Model with a DVD-ROM Drive)
Set to "2"
Set to "2"
24