Ram Module - Panasonic Toughbook CF-50 Series Reference Manual

RAM Module

Inserting/Removing RAM Module
Screw
Memory Cover
RAM Module
RAM Module Slot
Hooks
Use a RAM module meeting the RAM module specifications below. If a module is
used that does not meet the specifications, there are cases in which data may
become unusable or the computer may not operate properly.
RAM module specifications
200 pins, SO-DIMM, DDR-SDRAM, PC2100 Compliant
Only a RAM module designed for PC2100 can be added.
CAUTION
RAM modules are extremely sensitive to static electricity. There are cases
where static electricity generated by the human body has adversely affected
such modules. When inserting or removing a RAM module, do not touch the
terminals or internal components, insert objects other than the module, or al-
low foreign particles to enter. Doing so has been known to cause damage, fire
or electric shock.
1
Power off your computer
Do not shut down using the standby or hibernation function.
Disconnect the AC adaptor, turn the computer over and remove the battery
pack.
2
Turn the computer over and remove the memory cover after
removing the screw holding it in place
3
Inserting the RAM module
1 Slide in the module at an angle.
2 Snap the module into place by pushing down on it.
Removing the RAM module
1 Open the left and right hooks.
2 Gently remove the RAM module from the slot.
4
Put the cover back into place
1 Insert the cover diagonally, then fit it in place.
2 Fasten the screw.
NOTE
Whether the RAM module is properly recognized or not can be confirmed
in [Information] of the Setup Utility (
not recognized, power off the computer and insert it again.
( "Starting Up/Shutting Down")
page 44). If the RAM module is
30