Table of Contents
Advertisement
WATERAX VERSAX Owner's Manual
Parts Identification
VERSAX 6/9
A. Priming port (2" BSP)
B. Pump discharge (1" NPT)
C. Pump discharge (1-1/2" NPT)
D. Pump intake - suction (2" NPT)
E. Pump drain
F. Oil fill
(not shown)
G. Ignition switch
H. Recoil starter*
I.
Fuel cap
J.
Throttle
(not shown)
K. Fuel valve
(not shown)
L. Choke
(not shown)
M. Muffler
Note: VS2-6 model shown with GX200 engine. Carry
handle available on portable models.
* Electric starter available on GX270E engine
models
Installation
Depending on your model and configuration ordered, you may require additional
accessories from WATERAX or from third-party vendors, for example, control panels and
batteries. You will also require hoses and nozzles as well as other fire apparatus
plumbing which can be purchased through your WATERAX representative. Follow the
instructions and heed all warnings in any documentation that you receive with the
accessories you purchase.
Plumbing
When installing any plumbing on a pump fixed to a platform, the plumbing MUST be self-
supported and coupled to the pump by means of a flex coupling such as a Victaulic®
coupling or flex hose.
Fastening to Truck/Apparatus
When adding any equipment to a vehicle, follow all instructions and heed all warnings
provided by manufacturers of the apparatus and any third-party accessories. WATERAX
provides certain accessories used in vehicle-mount configurations of the VERSAX series
pumps. Follow all documentation that ships with any accessories you have ordered.
Before installing the pump in a vehicle, plan for adequate access to any fill caps such as
those for oil or fuel, as well as any other part of the pump or engine that is frequently
accessed or inspected (valves, panels, filters, etc.). Make note of components that
become hot when operating such as mufflers and engine blocks, and always ensure a
safe clearance around them.
6
K L
J
I
H
G
F
M
A
B
C
D
E
11/2015
Advertisement
Table of Contents
