Table of Contents
Advertisement
WATERAX STRIKER-2/3 Owner's Manual
Parts Identification
STRIKER-2/3
A. Pump intake (suction)
B. Pump drain port
C. Priming valve
D. Quick release pump clamp
E. Discharge check valve*
F. Pump discharge
G. Hand primer*
H. Ignition switch
I.
Recoil starter
J.
Fuel cap
K. Throttle
(not shown)
L. Fuel valve
(not shown)
M. Choke
(not shown)
N. Muffler
Note: Portable 2-stage STRIKER-2 pump model
shown. Other configurations available for both 2-
stage STRIKER-2 and 3-stage STRIKER-3 pumps.
* Available on portable models.
Installation
Depending on your model and configuration ordered, you may require additional
accessories from WATERAX or from third-party vendors, for example, control panels,
batteries, and fuel lines. You will also require hoses and nozzles as well as other fire
apparatus plumbing which can be purchased through your WATERAX representative.
Follow the instructions and heed all warnings in any documentation that you receive with
the accessories you purchase.
Plumbing
When mounting manifolds to the pump, the manifolds must be self-supporting and
coupled to the pump by means of a flex coupling such as a Victaulic® coupling or flex
hose.
Pump End Mounting
The pump end can be rotated to aid with the apparatus piping connections. The quick
release pump clamp securely holds the pump end in the desired position. Always ensure
that the water can be drained from the pump end to keep it from cracking in freezing
weather. A drain valve is available from WATERAX (item no 801104).
6
(not shown)
Page 6
L
M
K
J
I
H
G
F
E
N
A
B
C
D
04/2015
Advertisement
Table of Contents
