Replacing The Rubber Feet; Procedure; Post-Requisites - Dell Inspiron 20 3000 Series Service Manual

Replacing the rubber feet

WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before working inside your
computer, follow the instructions in
computer. For more safety best practices, see the Regulatory
Compliance home page at www.dell.com/regulatory_compliance.

Procedure

1 Align the screw holes on the rubber feet with the screw holes on the
display bezel.
2 Replace the screws that secure the rubber feet to the display bezel.

Post-requisites

1 Follow the procedure in step 2 to step 6 in
assembly".
2 Replace the system
3 Replace the wireless
4 Replace the speakers.
5 Replace the memory
6 Replace the heat
7 Replace the fan.
8 Replace the system-board
9 Follow the procedure in step 3 to step 7 in
10 Replace the back
11 Follow the procedure in step 4 in
12 Replace the stand.
80
computer. After working inside your
board.
card.
module.
sink.
shield.
cover.
"Replacing the optical
After working inside your
"Replacing the display
"Replacing the hard-drive".
drive".