Ec Declaration Of Conformity - Flymo Hover Vac Original Instructions Manual

If any part is found to be defective due to faulty manufacture
within the guarantee period, Husqvarna UK Ltd., through its
Authorised Service Repairers will effect the repair or replace-
ment to the customer free of charge providing:
(a) The fault is reported directly to the Authorised Repairer.
(b)Proof of purchase is provided.
(c)The fault is not caused by misuse, neglect or faulty adjust-
ment by the user.
(d)The failure has not occurred through fair wear and tear.
(e)The machine has not been serviced or repaired, taken
apart or tampered with by any person not authorised by
Husqvarna UK Ltd..
(f) The machine has not been used for hire.
(g)The machine is owned by the original purchaser.
(h)The machine has not been used commercially.
* This guarantee is additional to, and in no way diminishes
the customers statutory rights.
Failures due to the following are not covered, therefore it is
important that you read the instructions contained in this Op-
erator's Manual and understand how to operate and maintain
your machine:
Husqvarna AB, 561 82, Huskvarna, Sweden
Declare under our sole responsibility that the product(s);
Category............................Electric Lawn Trimmer
Type(s) ............................HV2800
Identification of Series.......See Product Rating Label
Year of Construction..........See Product Rating Label
Conforms to the essential requirements & provisions of the following EC Directives:
98/37/EC (until 28.12.09), 2006/42/EC (from 29.12.09), 2004/108/EC, 2000/14/EC
based on the following EU harmonized standards applied:
EN60335-1, EN60335-2-91, EN786, EN50366, EN55014-1, EN61000-3-2, EN61000-3-3
The maximum A weighted sound pressure level L
product(s) corresponds to the Level given in the table.
The maximum hand / arm vibration weighted value measured according to EN ISO 5349 on a sample of the above
product(s) corresponds to the Value ah given in the table.
2000/14/EC: The Measured Sound Power L
figures.
Conformity Assessment Procedure...............
Notified Body.................................................
Newton Aycliffe 15/12/2009
M.Bowden
Research & Development Director
Husqvarna UK Ltd.
Keeper of technical documentation
Our policy of continuous improvement means that the specification of products may be altered from time to time without prior notice.
Copyright © 2008 Flymo S.A. All rights reserved. Flymo® and other product and feature names are registered or unregistered trademarks
5051967-02
Guarantee & Guarantee Policy

EC Declaration of Conformity

pA
& Guaranteed Sound Power L
WA
Annex VI
Intertek, Cleeve Road
Leatherhead, Surrey
KT22 7SB, England
Type
Width of Cut (mm)
Speed of Rotation of Cutting Device (rpm)
Power (kW)
Measured Sound Power L
Guaranteed Sound Power L
Level (dB(A))
Value ah (m/s 2 )
Uncertainty K of ah (m/s
Weight (Kg)
Failures not covered by guarantee
* Replacing worn or damaged plastic cutters.
* Failures as a result of not reporting an initial fault.
* Failures as a result of sudden impact.
* Failures as a result of not using the product in accordance
with the instructions and recommendations contained in
this Operator's Manual.
* Machines used for hire are not covered by this guarantee.
* The following items listed are considered as wearing parts
and their life is dependent on regular maintenance and are,
therefore not normally subject to a valid warranty claim:
Plastic cutters, Cutting head, Electric Mains cable.
* Caution!
Husqvarna UK Ltd. does not accept liability under the war-
ranty for defects caused in whole or part, directly or indi-
rectly by the fitting of replacement parts or additional parts
that are not either manufactured or approved by Husqvarna
UK Ltd., or by the machine having been modified in any
way
at the operator's position, recorded on a sample of the above
(dB(A))
WA
(dB(A))
WA
2 )
of Flymo S.A.
Husqvarna AB
561 82
Huskvarna
Sweden
values are according to the tabulated
WA
HV2800
28
7350
0.9
92
93
80.9
2.38
1.5
6.3