Time-Setting Options; Programming The Cooking Time; The Kitchen Timer - Siemens EH series Instruction Manual

OTime-setting options
Your hob has two timer functions:
i o n s T i m e - s e t t i n g o p t

Programming the cooking time

■
Kitchen timer
■
Programming the cooking time
The hotplate automatically switches off after the time
that is set has elapsed.
Setting procedure:
Select the hotplate and the required heat setting.
1.
Touch the 0 symbol.
2.
the hotplate. lights up on the timer display.
‹‹
Within the next 10 seconds, set the required cooking
3.
time in the settings range. From left to right, the
presetting can be chosen from 1, 2, 3, etc., to
10 minutes.
After a few seconds, the time begins to elapse.
The same cooking time can be set automatically
Note:
for all hotplates. The set time for each of the hotplates
counts down independently.
You can find information on automatically programming
the cooking time in section ~ "Basic settings"
Automatic programming
If the previous setting from 1 to 5 is pressed in the
programming zone, the cooking time is reduced by one
minute.
If the previous setting from 6 to 10 is pressed in the
programming zone, the cooking time is increased by
one minute.
Changing or cancelling the time
Select the hotplate and then press the
Change the cooking time using the programming zone
or set to in order to cancel the time.
‹‹
x lights up on the display for
symbol.
0
Once the time has elapsed
The hotplate switches off. A warning signal sounds. The
time program function lights up
the display.
When the 0 symbol is pressed, the indications turn off
and the beeping stops.
Notes
If a cooking time was programmed for several
■
hotplates, the time information for the selected
hotplate is shown in the timer display.
You can set a cooking time of up to 99 minutes.
■

The kitchen timer

You can use the kitchen timer to set a time of up to 99
minutes.
This functions independently from the hotplates and
from other settings. This function does not automatically
switch off a hotplate.
Programming
Press the symbol several times until the
0
1.
indicator lights up.
‹‹
function display.
Select the desired time in the programming panel.
2.
The timer starts to count down after a few seconds.
Changing or cancelling the time
Press the symbol several times until the
0
lights up. Change the time with the programming zone,
or set to .
‹‹
Once the time has elapsed
A warning signal sounds. In the time program function
display is shown, and the
‹‹
After 10 seconds the indicators turn off.
When the symbol is pressed, the indicators turn off
0
and the beeping stops.

Time-setting options

for 10 seconds in
‹‹
W
lights up in the time program
indicator
W
indicator lights up.
W
en
13