Suitability Test Of Tableware; Cleaning; Hob; Hob Surround - Siemens EH series Instruction Manual

Suitability test of tableware

en
tSuitability test of tableware
This function can be used to check the speed and
t o f t a b l e w a r e S u i t a b i l i t y t e s
quality of the cooking process depending on the
cookware.
The result is a reference value and depends on the
properties of the cookware and the hotplate being used.
With the cookware still cold, fill it with approx.
1.
200 ml of water and place it on the centre of the
hotplate with the diameter that most closely matches
that of the base of the cookware.
Go to the basic settings and select the
2.
Touch the settings range.
3.
display.
The function has now been activated.
After 10 seconds, the result for the quality and speed of
the cooking process will appear on the hotplate display.
Check the result using the following table:
Result
The cookware is not suitable for the hotplate and will therefore
‹
not heat up.*
The cookware is taking longer to heat up than expected and the
‚
cooking process is not going as well as it should.*
The cookware is heating up correctly and the cooking process
ƒ
is going well.
* If there is a smaller hotplate available, test the cookware again on the
smaller hotplate.
To reactivate this function, touch the settings range.
Notes
If the diameter of the hotplate used is much smaller
■
than the diameter of the cookware, only the middle
of the cookware can be expected to heat up. This
may result in the cooking results not being as good
as expected or being less than satisfactory.
You can find information on this function in the
■
section on ~ "Basic settings".
You can find information on the type, size and
■
positioning of the cookware in the section on
~ "Induction cooking".
18
setting.
™‚ƒ
will flash on the hotplate
A
DCleaning
Suitable maintenance and cleaning products can be
C l e a n i n g
purchased from the after-sales service or in our e-Shop.

Hob

Cleaning

Always clean the hob after cooking. This will prevent
food deposits from becoming burned on. Only clean the
hob after the residual heat indicator has gone out.
Clean the hob with a damp dish cloth and dry it with a
cloth or towel to prevent limescale build-up.
Only use cleaning agents that are suitable for this type
of hob. Observe the manufacturer's instructions on the
product packaging.
Never use:
Undiluted washing-up liquid
■
Cleaning agents designed for dishwashers
■
Abrasive cleaners
■
Harsh cleaning agents, such as oven spray and
■
limescale remover
Scouring pads
■
High-pressure cleaners or steam jet cleaners
■
Stubborn dirt is best removed with a glass scraper,
available from retailers. Observe the manufacturer's
instructions.
You can obtain a suitable glass scraper from customer
services or through our online shop.
Using a special sponge for cleaning glass-ceramic
hobs achieves a great cleaning result.
Potential marks
Limescale and water Clean the hob as soon as it has cooled down.
marks You can use a cleaning agent suitable for
glass-ceramic hobs.*
Sugar, rice starch or Clean immediately. Use a glass scraper. Cau-
plastic tion: Risk of burns.*
* Then clean with a damp dish cloth and dry with a cloth or towel.
Do not use any cleaning agents while the hob is
Note:
still hot. This may mark the surface. Make sure that any
residue left by cleaning agents is removed.

Hob surround

To prevent damage to the hob surround, observe the
following instructions:
Only use warm soapy water
■
Wash new dish cloths thoroughly before use.
■
Do not use harsh or abrasive cleaning agents.
■
Do not use a glass scraper or sharp objects.
■