Honeywell HW5600C Owner's Manual page 14

Assembly
Step 2: Install Wheel Axle and Wheels
To install wheel assembly, you will need:
‰ Wheel axle (1)
‰ M10 x 16 mm long full-thread hex bolts (4)
‰ M13 serrated flange nuts (4)
*
‰ Axle bracket
(1)
‰ Wheels (2)
‰ M16 x 30 mm OD x 2.5 mm washers (2)
‰ Snap pins (2)
‰ 10 mm open end wrench
‰ Socket wrench with 13 mm socket
* Two brackets are needed to install wheel axle. One bracket
comes already attached to wheel axle; other bracket is included
in accessory kit box.
† Not included.
Install wheel axle brackets to frame using 16 mm long
1.
full-thread hex bolts and serrated flange nuts.
Install pre-attached bracket to frame first.
1A.
NOTE:
Axle brackets are offset (one side longer than the other),
place with the short side up during installation.
Install other bracket to frame.
1B.
FIGURE 8: Wheel Axle Attached to Generator
8 www.honeywellgenerators.com
†
†
On each end of axle:
Slide and push wheel onto axle until it fits snug
2.
against washer.
FIGURE 9: Slide Wheel onto Wheel Axle
Slide a washer onto axle.
3.
Slide snap pin into pre-drilled hole until fully seated.
4.
FIGURE 10: Snap Pin Installation
Return generator to upright position (so that wheels
5.
and leg supports are touching the ground).
HW5600C Portable Electrical Generator Owner's Manual