Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Shark Vancore
Summary of Contents for Shark Vancore
- Page 1 SHARK Vancore...
-
Page 4: Table Of Contents
• SHARKTOOTH ............13 • Ventilation ..............14 • Warranty ..............15 • Legal informations ........... 16 Thank you for choosing a Vancore hel- It therefore meets the requirements imposed on all the countries that recognize met. The Vancore is a top-quality helmet this standard in their territory. -
Page 5: Anatomy Of The Helmet
anatoMy oF tHe HelMet 7 - “Precise Lock“ buckle 1) Goggles 4) Chip strap 2) Top ventilation 5) Visor seal 3) QRGS (quick release goggles system) 6) Chin bar... -
Page 6: A Helmet In Your Size
Try the size of Vancore helmet closest to the tightened. measurement obtained, starting with the size Keep trying on helmets until you find the smaller than your head measurement. -
Page 7: Chin Strap Micrometric Buckle
cHin StraP MicroMetric bUckle aDViSe For USe to remove, reverse operations Position the protective parts of the chin strap 1/ Putting on the helmet buckle correctly and fasten it in accordance Once the chin strap is released, you have to with the recommendations that are appro- take hold of the two sections by the buckles priate to the versions and country. -
Page 8: Advice For Use: Put And Remove
(Figs. A, B, C and D) Warning! never ride with the chin strap loose or insufficiently tightened. even Choose your Vancore and attach the holding though the interior padding gives you the system. When the “Precise Lock” is adjusted to... -
Page 9: Goggles, Qrgs System, Maintenance
When cleaning the lens, use the European standard IN 1938 2010. Your lukewarm water (below 40 degrees) and Vancore helmet has a pair of goggles Optic a soft cloth in microfiber delivered with by Carl Zeiss used as glasses of protection goggles to wipe the lens. - Page 10 goggles • système qrgs aSSeMbly DiSMantling Position the right strap fixing on his pin (B). To unsettle the whole helmet, you just have Place the goggles in their final position (C). to take off the plastic part fixed to elastic Attach the left strap fixing on its pin using bandages, the side part of goggles (A).
-
Page 11: Textile Parts : Type, Treatment, Dismounting And Maintenance
The textile and foam parts providing com- selection not correspond to the contours fort to the Vancore make it easy for you of your face. to appreciate the performance of your helmet to the best. The parts in contact... - Page 12 textile Remove the front plastic support from Its loca- Dismantling tion. To end it, remove the cap. Inside textile parts can be fully dismantled. Turn rePlace over the helmet, open the chin strap buckle. Insert the front plastic part of the cap in its Unclip cheek Velcro, and release chin strap location (D).
-
Page 13: Easy Fit
Fit - SHarktootH SHarktootH Your helmet SHARK Vancore is designed to be equipped with audio system SHARKTOOTH. You will find a specific location designed for battery at the rear of the helmet, behind the neck pad (A) and a space for the micro- phone to the front of the helmet. -
Page 14: Ventilation
Ventilation The quality and design of textile comfort par- To maximize comfort including ventilation of Vancore, R&D has produced a new concept ticipate in the dissemination of good air. The combining creating air channels position of the upper ventilation is determined in the damping elements and insertion to maximize the effectiveness of its air intake. -
Page 15: Warranty
(scratches, marks, etc.) If SHARK is unable to carry out the repair for technical 6) abnormal and prolonged exposure to ultra- violet reasons or because a component is not available, SHARK light, in particular for the decorative colours. -
Page 16: Legal Informations
Do not apply any paint, stickers, petrol or any other solvent to SHARK reserves the right to improve the quality of production. The images this helmet. Only the goggles approved under No VZ 7400 NF EN 1938 2010 contained in this document are SHARK’s exclusive property. Any repro- must be used with this helmet.
Need help?
Do you have a question about the Vancore and is the answer not in the manual?
Questions and answers